Programming Guide for 2004 Keyless Entry Remote Fob

Important Notice: For successful programming, follow the steps in order. Ensure all connections are secure and precise. If the procedure does not work, consider seeking professional help.

Step-by-Step Programming Instructions:

• Step 1: Locate the Data Port Find the Data Port, which is located under the driver’s side dashboard, typically to the right of the steering column.
• Step 2: Insert the Keys into the Ignition Insert the vehicle keys into the ignition and leave it in the OFF position.
• Step 3: Verify Metal Contact Pins and Connect the Jumper Wire Check that terminals 1 and 4 have metal contact pins. Connect the Data Port terminals 1 and 4 with a suitable jumper wire. Keep the jumper wire connected for the entire programming process. Be sure you know which terminals are 1 and 4.
• Step 4: Activate Programming Mode Within 10 seconds of connecting the jumper wire, press the Hazard Switch six times. The doors will automatically lock and unlock once, signaling that the system has entered programming mode.
• Step 5: Program the First Remote Press the LOCK button on the remote you want to register three times within 10 seconds. If the programming is successful, the doors will lock and unlock once to confirm.
• Step 6: Program Additional Remotes Repeat Step 5 for up to 4 remotes (including existing remotes) within one minute. After each remote is programmed, the doors will lock and unlock once to confirm the registration.
• Step 7: Test the Remotes Test all programmed remotes by pressing the lock/unlock buttons to ensure they are functioning correctly.
• Step 8: Disconnect the Jumper Wire Once all remotes have been successfully programmed, disconnect the jumper wire from the Data Port.
• Step 9: Remove the Keys from the Ignition Finally, remove the keys from the ignition to complete the programming procedure.