Programming Guide for 2004 Mitsubishi Endeavor Keyless Entry Remote Fob

Important Notice: Follow each step carefully to ensure the successful programming of your keyless entry remote fob. If the process does not work as expected, professional assistance may be needed.

Step-by-Step Instructions:

• Step 1: Locate the Data Port Find the Data Port under the driver’s side dashboard, typically located to the right of the steering column.
• Step 2: Insert the Keys into the Ignition Place the vehicle keys into the ignition and turn the ignition to the OFF position.
• Step 3: Ensure Metal Contact Pins and Connect the Jumper Wire Verify that there are metal contact pins in terminals 1 and 4 of the Data Port. Use a suitable jumper wire to connect terminals 1 and 4. Keep the jumper wire connected throughout the entire programming procedure. Be sure to know which terminals are 1 and 4.
• Step 4: Activate Programming Mode Within 10 seconds after connecting the jumper wire, press the Hazard Switch six times. The doors will automatically lock and unlock once, indicating the system has entered programming mode.
• Step 5: Program the First Remote Press the LOCK button on the remote you wish to program three times within 10 seconds. If successful, the doors will lock and unlock once to confirm that the remote has been registered.
• Step 6: Program Additional Remotes To program additional remotes, repeat Step 5 within one minute for each remote. You can program up to 4 remotes, including any existing remotes. After programming each remote, the doors will lock and unlock once to confirm successful registration.
• Step 7: Test the Remotes Test each remote by pressing the lock/unlock buttons to verify their functionality.
• Step 8: Disconnect the Jumper Wire Once all remotes have been successfully programmed, disconnect the jumper wire from the Data Port.
• Step 9: Remove the Keys from the Ignition Finally, remove the keys from the ignition to complete the programming process.