2004 Toyota Camry

2004 Toyota Camry Keyless Entry Remote Fob Programming Guide

Important Notice: This vehicle supports onboard programming for remote key fobs. No special tools are required, but the procedure must be followed precisely, with close attention to timing. Up to four remotes can be programmed in a single session.

Programming Procedure:

  • Step 1: Prepare the Vehicle Ensure the key is removed from the ignition. Open the driver’s door and leave it open. Confirm all other doors are closed. Ensure the driver’s door is unlocked.
  • Step 2: Insert and Remove Key Twice (Within 5 Seconds) A. Insert the key into the ignition (do not turn), then remove it. B. Insert the key again (do not turn), then remove it.
  • Step 3: Door Cycling and Key Insert (Within 40 Seconds) A. Close, then open the driver’s door. B. Close, then open the driver’s door again. C. Insert the key into the ignition (do not turn), then remove it.
  • Step 4: Final Setup (Within 40 Seconds) A. Close, then open the driver’s door. B. Close, then open the driver’s door again. C. Insert the key into the ignition and leave it in place. D. Close the driver’s door. E. Turn the ignition to the ON position (do not start the engine), then turn it OFF. F. Remove the key from the ignition.
  • Step 5: Enter Programming Mode Within 3 seconds, the power door locks should automatically lock and then unlock, confirming entry into programming mode. If the locks do not cycle, restart the procedure from Step 1.
  • Step 6: Program Each Remote (Within 40 Seconds Per Remote) For each remote: A. Press and hold the lock and unlock buttons together for 1.5 seconds, then release. B. Immediately press and hold the lock button alone for 2 seconds, then release. C. The door locks should cycle once, confirming successful programming. If the locks cycle twice, the remote was not accepted. Repeat steps A and B.
  • Step 7: Exit Programming Mode Repeat Step 6 for each additional remote. When all remotes are programmed, open the driver’s door to exit programming mode.

Additional Notes:

  • A maximum of four remotes can be programmed. All remotes must be programmed during the same session. If any step is delayed or missed, the process must be restarted from Step 1.