<h1>Remote Fob Programming Guide for 2005 RSX</h1> <p><font size="3"><b>Note:</b> The system stores up to three remote transmitters. If a fourth is added, the oldest code will be overwritten. All doors and the rear hatch must remain closed. Follow each step within 1 to 4 seconds unless otherwise noted. </font></p> <p><font size="3"><b>Programming Steps:</b></font></p> <ul> <li><font size="3"> Step 1: Turn the ignition switch to the ON (II) position. </font></li> <li><font size="3">Step 2: Within 4 seconds, press the LOCK or UNLOCK button on the remote while aiming it toward the receiver, located beneath the audio unit. </font></li> <li><font size="3">Step 3: Turn the ignition switch to OFF. </font></li> <li><font size="3">Step 4: Within 4 seconds, turn the ignition back to ON (II). </font></li> <li><font size="3">Step 5: Press the LOCK or UNLOCK button again while aiming at the receiver. </font></li> <li><font size="3">Step 6: Turn the ignition switch OFF. </font></li> <li><font size="3">Step 7: Within 4 seconds, turn the ignition to ON (II). </font></li> <li><font size="3">Step 8: Press the LOCK or UNLOCK button again while aiming at the receiver. </font></li> <li><font size="3">Step 9: Turn the ignition switch OFF. </font></li> <li><font size="3">Step 10: Within 4 seconds, turn the ignition back to ON (II). </font></li> <li><font size="3">Step 11: Press the LOCK or UNLOCK button on the remote again while aiming at the receiver.</font></li> <li><font size="3"> Step 12: The door locks should cycle, confirming the vehicle is in programming mode. Press the LOCK or UNLOCK button once more.</font></li> <li><font size="3"> Step 13: Within 10 seconds, program up to two additional remotes by pressing the LOCK or UNLOCK button on each. The door locks should cycle after each successful programming. </font></li> <li><font size="3">Step 14: Turn the ignition switch OFF and remove the key. </font></li> <li><font size="3">Step 15: Test all remotes to confirm proper operation.</font></li> </ul>
