<h1>2005 Honda Accord Keyless Entry Remote Fob Programming Instructions</h1> <p><font size="3"><b>Important Notice:</b> Entering programming mode will erase all previously programmed remotes. After entering programming mode, all remotes must be reprogrammed. Be sure to complete each step within 5 seconds of the previous one to prevent the system from exiting programming mode prematurely.</font></p> <p><font size="3"><b> Programming Procedure:</b> </font></p> <ul> <li><font size="3">Step 1: Turn the ignition switch to the ON (II) position, which powers up the vehicle's electronics but does not start the engine. </font></li> <li><font size="3">Step 2: Press the LOCK or UNLOCK button on one of the remotes. (You can use an un-programmed remote for this step.) </font></li> <li><font size="3">Step 3: Turn the ignition switch to the LOCK (0) position. This temporarily powers off the vehicle’s electronics, preparing it for reprogramming. </font></li> <li><font size="3">Step 4: Repeat Steps 1, 2, and 3 two more times, using the same remote that was used in Step 2. Make sure to complete each step within 5 seconds to keep the system in programming mode. </font></li> <li><font size="3">Step 5: Turn the ignition switch to the ON (II) position again. The vehicle will now be in programming mode.</font></li> <li><font size="3"> Step 6: Press the LOCK or UNLOCK button on the same remote used in Step 2. The power door locks should cycle (lock and unlock) to confirm that the vehicle is in programming mode. </font></li> <li><font size="3">Step 7: Press the LOCK or UNLOCK button on each additional remote you wish to program. The door locks should cycle each time you press the remote button, confirming that the system has successfully accepted the remote. </font></li> <li><font size="3">Step 8: Repeat Step 7 for each additional remote. The door locks will cycle each time to indicate successful programming. </font></li> <li><font size="3">Step 9: Once all remotes are programmed, turn the ignition switch to the LOCK (0) position to exit programming mode. This saves the programming and prevents any further remotes from being added.</font></li> <li><font size="3"> Step 10: Test each remote by pressing the LOCK and UNLOCK buttons. The door locks should respond by locking and unlocking, confirming that the remotes are functioning properly. </font></li> </ul> <p><b><font size="3">Note:</font></b></p> <ul> <li><font size="3"> Remote Head Key Programming: If your vehicle uses a Remote Head Key, you can follow the steps above to program the remote portion of the key. However, the key blade must be cut and programmed to match the vehicle’s ignition system to start the engine. </font></li> <li><font size="3">Key Cutting: The key blade portion must be properly cut and programmed to work with the vehicle’s ignition system.</font></li> </ul>
