<h1>2005 Honda Element – Keyless Entry Remote Fob Programming Instructions</h1> <p><font size="3"><b> Important Notice:</b> Activating programming mode will erase all previously stored remote codes. Every remote you intend to use must be programmed during the same session. If a remote is skipped, it will no longer function. To remain in programming mode, you must complete each step within five seconds of the previous one. </font></p> <ul> <li><font size="3">Step 1: Sit in the driver’s seat and ensure all doors are unlocked. Close all doors securely. Insert the key into the ignition, but do not turn it yet. Make sure all the remotes you wish to program are within reach. </font></li> <li><font size="3">Step 2: Turn the ignition switch to the ON (II) position. The dashboard warning lights should illuminate, but the engine should remain off. This begins the first cycle necessary to access programming mode.</font></li> <li><font size="3"> Step 3: Within five seconds, press either the LOCK or UNLOCK button on the first remote. You may use a new or previously programmed remote for this step.</font></li> <li><font size="3"> Step 4: Turn the ignition switch back to the LOCK (0) position. This ends the first cycle in the programming sequence.</font></li> <li><font size="3"> Step 5: Repeat Steps 2 through 4 two more times. Each time, turn the ignition to ON (II), press the remote button, then turn the ignition back to LOCK (0). You should complete a total of three full ON → button press → OFF cycles. Each cycle must happen quickly to keep the system engaged. </font></li> <li><font size="3">Step 6: After the third cycle, turn the ignition to the ON (II) position once more. You should now be in remote programming mode. </font></li> <li><font size="3">Step 7: Press the LOCK or UNLOCK button again on the same remote. The vehicle’s door locks should automatically cycle (lock and then unlock) to confirm that programming mode has been successfully accessed. </font></li> <li><font size="3">Step 8: Within five seconds, press the LOCK or UNLOCK button on the next remote you want to program. Wait for the door locks to cycle before continuing. This indicates the remote has been accepted. </font></li> <li><font size="3">Step 9: Repeat Step 8 for any additional remotes you need to program. Each time, wait for the door locks to cycle after pressing the button on the remote. If the locks do not respond, restart the entire process.</font></li> <li><font size="3"> Step 10: Once all remotes have been programmed, turn the ignition back to the LOCK (0) position. This action exits the programming mode and stores all newly programmed remotes in memory. </font></li> <li><font size="3">Step 11: Remove the key from the ignition. Wait a few seconds, then test each remote by pressing the LOCK and UNLOCK buttons. Ensure all remotes function properly with the vehicle before finishing. </font></li> <li><font size="3">Step 12: If any remote fails to respond, repeat the programming steps from the beginning. Check that all steps are performed quickly and correctly, as timing is critical.</font></li> </ul>
