2005 Lincoln Navigator

<h1>Programming a Keyless Entry Remote for 2005 Navigator – Step-by-Step Guide</h1> Important: This guide explains how to program keyless entry remote fobs for the 2005 Lincoln Navigator. You must program all remotes during the same session; otherwise, any unprogrammed remotes will be erased. Make sure all remotes are prepared and ready before starting. Complete each step within the specified time limits. If any step fails, wait at least 10 seconds before restarting the process. Review all instructions before beginning. Remote Fob Programming Steps: <ul> <li>Step 1: Ensure all doors are securely closed. </li> <li>Step 2: Open the driver’s door and leave it open during the process. </li> <li>Step 3: Press and hold the UNLOCK button on the driver’s door panel. </li> <li>Step 4: Insert the key into the ignition while holding the unlock button. </li> <li>Step 5: Turn the ignition from OFF to RUN (do not start the engine). </li> <li>Step 6: Repeat the OFF to RUN cycle eight times within 10 seconds, ending with the key in the RUN position on the 8th turn. </li> <li>Step 7: The door locks will cycle (lock and unlock) to confirm that the vehicle has entered programming mode. </li> <li>Step 8: Release the unlock button. </li> <li>Step 9: Within 20 seconds, press any button on the first remote fob. </li> <li>Step 10: The door locks will cycle to confirm that the first remote has been successfully programmed. </li> <li>Step 11: Within 20 seconds, press any button on the second remote fob, if applicable. </li> <li>Step 12: The door locks will cycle again to confirm programming of the second remote. </li> <li>Step 13: Repeat this for any additional remotes, up to the system’s capacity. </li> <li>Step 14: Turn the ignition to the OFF position. </li> <li>Step 15: The door locks will cycle one last time to signal the end of programming mode.</li> </ul>

2005 Lincoln Navigator

Join our newsletter