Programming Instructions for 2005 Mazda B-Series Keyless Entry Remote Fob

Important Notice: The 2005 Mazda B-Series allows on-board programming for keyless entry remotes. This process enables up to two remotes to be programmed in a single session. Follow each step carefully and complete actions within the required time limits.

Programming Procedure:

• Step 1: Make sure all doors are fully closed and the ignition is turned off.
• Step 2: Open the driver’s door, press the UNLOCK button on the door panel, and keep the door open throughout the procedure.
• Step 3: Insert the key into the ignition switch.
• Step 4: Turn the ignition from OFF to RUN (just before the engine starts) eight times within 10 seconds, finishing in the RUN position on the eighth turn. – The door locks will cycle, indicating the system has entered programming mode.
• Step 5: Within 20 seconds, press any button on the first remote. – The door locks will cycle again, confirming the remote has been successfully programmed.
• Step 6: Within the next 20 seconds, press any button on the second remote (if available). – The locks will cycle, signaling that the second remote is also programmed.
• Step 7: Turn the ignition switch to the OFF position. – The door locks will cycle one final time, confirming the programming session has ended.
• Step 8: Test each remote to ensure that both lock and unlock functions are operating correctly.
• Step 9: If programming fails, repeat the entire procedure from Step 1, ensuring all timing requirements are met.