2006 Acura RSX

<h1>Programming Procedure for 2006 RSX Remote Keyless Entry Fob</h1> Important: Up to three remote transmitters can be programmed. If a fourth is added, the earliest stored remote will be erased. Ensure all doors and the hatch are closed. Each step must be performed within 1 to 4 seconds unless otherwise noted. Step-by-Step Instructions: <ul> <li> Step 1: Turn the ignition switch to the ON (II) position. </li> <li>Step 2: Within 4 seconds, press the LOCK or UNLOCK button on the remote while aiming it at the receiver, located beneath the audio unit. </li> <li>Step 3: Turn the ignition switch to OFF. </li> <li>Step 4: Turn the ignition switch back to ON (II) within 4 seconds.</li> <li> Step 5: Press the LOCK or UNLOCK button again while aiming at the receiver.</li> <li> Step 6: Turn the ignition switch OFF. </li> <li>Step 7: Turn the ignition switch ON (II) again within 4 seconds. </li> <li>Step 8: Press the LOCK or UNLOCK button once more while pointing at the receiver. </li> <li>Step 9: Turn the ignition switch OFF. </li> <li>Step 10: Turn the ignition switch ON (II) within 4 seconds. </li> <li>Step 11: Press the LOCK or UNLOCK button again while aiming at the receiver. </li> <li>Step 12: The door lock actuators should cycle, confirming the system has entered programming mode. Press the LOCK or UNLOCK button again to store the first remote. </li> <li>Step 13: Within 10 seconds, aim up to two additional remotes at the receiver and press the LOCK or UNLOCK button on each. The door locks should cycle after each one is accepted. </li> <li>Step 14: Turn the ignition switch OFF and remove the key. </li> <li>Step 15: Test all programmed remotes to verify proper operation.</li> </ul>

2006 Acura RSX

Join our newsletter