<h1>Keyless Entry Remote Programming Guide – 2006 Model</h1> <p><font size="3"><b>Important Information:</b> Entering programming mode will erase all previously stored remotes. All remotes must be reprogrammed during the same session. To avoid exiting programming mode, each step must be completed within 4 seconds of the previous step. Each additional remote must be programmed within 10 seconds of the last. </font></p> <p><font size="3"><b>Step-by-Step Programming Instructions:</b> </font></p> <ul> <li><font size="3">Step 1: Insert the key and turn the ignition switch to the ""ON"" (II) position. </font></li> <li><font size="3">Step 2: Within 4 seconds, press the lock or unlock button on a remote (a previously unprogrammed remote may be used). </font></li> <li><font size="3">Step 3: Within 4 seconds, turn the ignition switch to the ""OFF"" (0) position. </font></li> <li><font size="3">Step 4: Within 4 seconds, turn the ignition switch back to the ""ON"" (II) position. </font></li> <li><font size="3">Step 5: Repeat Steps 2, 3, and 4 two more times using the same remote. This completes three full cycles.</font></li> <li><font size="3"> Step 6: Within 4 seconds, press the lock or unlock button on the same remote once again. If successful, the door locks will cycle to confirm the system is now in programming mode. </font></li> <li><font size="3">Step 7: Within 10 seconds, press the lock or unlock button on the same remote again to register it. </font></li> <li><font size="3">Step 8: Within 10 seconds of the last remote input, press the lock or unlock button on any additional remotes you wish to program. Wait for the door locks to cycle after each one to confirm successful registration.</font></li> <li><font size="3"> Step 9: Turn the ignition switch to the ""OFF"" (0) position to exit programming mode.</font></li> <li><font size="3"> Step 10: Test all remotes to ensure proper operation.</font></li> </ul>
