<h1>2006 GMC Yukon – Remote Fob Programming Instructions</h1> <p><font size="3"> The 2006 Yukon supports onboard programming for keyless entry remote fobs. Use the procedure below to program one or more transmitters.</font></p> <p><font size="3"><b> Programming Procedure</b> </font></p> <ul> <li><font size="3">Step 1: Ensure that all vehicle doors are closed. </font></li> <li><font size="3">Step 2: Insert the key into the ignition, but do not start the engine. </font></li> <li><font size="3">Step 3: Press and hold the power UNLOCK button on the driver’s door panel. – Continue holding this button until Step 9. </font></li> <li><font size="3">Step 4: Quickly perform the following ignition sequence: </font></li> <li><font size="3">Step 5: Turn the ignition to the ON position (as far as it goes without starting the engine).</font></li> <li><font size="3"> Step 6: Turn the ignition OFF. </font></li> <li><font size="3">Step 7: Turn the ignition ON again. </font></li> <li><font size="3">Step 8: Turn the ignition OFF again. </font></li> <li><font size="3">Step 9: Release the UNLOCK button on the driver’s door panel. – The door locks will lock and unlock, signaling that the vehicle has entered programming mode. </font></li> <li><font size="3">Step 10: On the first remote, press and hold both the LOCK and UNLOCK buttons at the same time. – Hold until the door locks cycle, confirming the remote has been successfully programmed. – This may take up to 30 seconds. </font></li> <li><font size="3">Step 11: Repeat Step 10 for any additional remotes, including those already in use. </font></li> <li><font size="3">Step 12: Turn the ignition to the ON position to exit programming mode. </font></li> <li><font size="3">Step 13: Test each remote to ensure proper function.</font></li> </ul>
