<h1>2006 Honda Accord Keyless Entry Remote Fob Programming Instructions Important</h1> <p><font size="3"><b> Notice:</b> Entering programming mode will erase all previously programmed remotes. After entering programming mode, you must reprogram all remotes. Be sure to complete each step within 5 seconds of the previous one to prevent the system from exiting programming mode prematurely. </font></p> <p><font size="3"><b>Programming Procedure:</b> </font></p> <ul> <li><font size="3">Step 1: Turn the ignition switch to the ON (II) position, which powers up the vehicle's electronics but does not start the engine.</font></li> <li><font size="3"> Step 2: Press the LOCK or UNLOCK button on one of the remotes. (An un-programmed remote can be used for this step.) </font></li> <li><font size="3">Step 3: Turn the ignition switch to the LOCK (0) position. This powers down the vehicle’s electronics temporarily and prepares the system for reprogramming. </font></li> <li><font size="3">Step 4: Repeat Steps 1, 2, and 3 two more times, using the same remote that was used in Step 2. Ensure that each step is completed within 5 seconds to keep the system in programming mode. </font></li> <li><font size="3">Step 5: Turn the ignition switch to the ON (II) position again. This will signal the vehicle that it is now in programming mode.</font></li> <li><font size="3"> Step 6: Press the LOCK or UNLOCK button on the same remote used in Step 2. The power door locks should cycle (lock then unlock), confirming that the vehicle has entered programming mode. </font></li> <li><font size="3">Step 7: Press the LOCK or UNLOCK button on each additional remote you wish to program. After pressing each button, the door locks should cycle again to confirm that the system has accepted the remote. </font></li> <li><font size="3">Step 8: Repeat Step 7 for each additional remote you want to program. The door locks will cycle after each press to confirm successful programming. </font></li> <li><font size="3">Step 9: Once all remotes are programmed, turn the ignition switch to the LOCK (0) position to exit programming mode. This action saves the programming and prevents further remotes from being added. </font></li> <li><font size="3">Step 10: Test each remote by pressing the LOCK and UNLOCK buttons. The door locks should respond by locking and unlocking, confirming that the remotes are working properly. </font></li> </ul> <p><font size="3"><b>Note:</b> </font></p> <ul> <li><font size="3">Remote Head Key Programming: If your vehicle uses a Remote Head Key, you can follow the steps above to program the remote portion of the key. However, the key blade must be cut and programmed to match the vehicle’s ignition system to start the engine. </font></li> <li><font size="3">Key Cutting: The key blade portion must be properly cut and programmed to work with the vehicle’s ignition system.</font></li> </ul>
