<h1>2006 Honda Civic Keyless Entry Remote Fob Programming Instructions</h1> <p><font size="3"><b>Important Notice:</b> Entering programming mode will erase all remotes previously programmed to the vehicle. You must reprogram all remotes you want to use once you have entered programming mode. Steps 1–12 must be completed within 5 seconds of each other to successfully enter programming mode. Each remote must be programmed within 10 seconds of pressing the button in Step 13.</font></p> <p><font size="3"><b>Programming Procedure:</b> </font></p> <ul> <li><font size="3">Step 1: Make sure all doors are unlocked before starting the programming process.</font></li> <li><font size="3"> Step 2: Insert the key into the ignition and turn it to the ON (II) position. → This powers the vehicle’s electrical system, but does not start the engine. </font></li> <li><font size="3">Step 3: Press either the LOCK or UNLOCK button on the remote you want to program. → This sends the first signal to initiate programming. </font></li> <li><font size="3">Step 4: Turn the ignition to the ACCESSORY (I) or LOCK (0) position. → This resets the ignition system, preparing it for the next step. </font></li> <li><font size="3">Step 5: Quickly turn the ignition back to the ON (II) position. → Continue moving through each step quickly to prevent exiting programming mode. </font></li> <li><font size="3">Step 6: Press the LOCK or UNLOCK button again on the same remote used in Step 3. → This confirms the remote’s signal. </font></li> <li><font size="3">Step 7: Turn the ignition to ACCESSORY (I) or LOCK (0) again. → This step resets the system to prepare for the next remote.</font></li> <li><font size="3"> Step 8: Turn the ignition back to the ON (II) position. → This ensures that the system remains in sync with the remote’s signal. </font></li> <li><font size="3">Step 9: Press the LOCK or UNLOCK button once more on the same remote. → This confirms that the remote is ready to be programmed. </font></li> <li><font size="3">Step 10: Turn the ignition to ACCESSORY (I) or LOCK (0). → This prepares the system for the final step before entering programming mode. </font></li> <li><font size="3">Step 11: Turn the ignition back to the ON (II) position again. → This step is necessary to finalize the programming sequence.</font></li> <li><font size="3"> Step 12: Press the LOCK or UNLOCK button on the same remote once more. → The door locks will cycle (lock then unlock), indicating that the vehicle has entered programming mode. </font></li> <li><font size="3">Step 13: To program each additional remote, press the LOCK button on each remote you wish to add. → The door locks will cycle each time a remote is successfully programmed. → The system can accept up to three remotes.</font></li> <li><font size="3"> Step 14: Once all remotes are programmed, turn the ignition to the LOCK (0) position. → This exits the programming mode and saves the remote settings. </font></li> <li><font size="3">Step 15: Test each remote by pressing the LOCK and UNLOCK buttons. → The doors should lock and unlock, confirming that the remotes are working correctly.</font></li> </ul>
