<h1>2006 Honda CR-V – Keyless Entry Remote Fob Programming Instructions</h1> <p><font size="3"><b> Important Notice:</b> When programming mode is activated, all previously stored remote fobs will be erased. To retain full functionality, you must reprogram every remote you intend to use during the same session. Additionally, each step must be performed within 5 seconds of the previous one. If the process times out, programming mode will cancel and must be restarted from the beginning. </font></p> <p><font size="3"><b>Programming Procedure:</b> </font></p> <ul> <li><font size="3">Step 1: Insert your key into the ignition switch. Turn the ignition to the ON (II) position. Do not start the vehicle—this step simply powers the electrical system. </font></li> <li><font size="3">Step 2: Press the LOCK or UNLOCK button on any one of the remote fobs. This action initiates the system’s remote recognition process. You may use a brand-new, unprogrammed remote for this step.</font></li> <li><font size="3"> Step 3: Turn the ignition switch to the LOCK (0) position. This completes one cycle in the programming sequence. </font></li> <li><font size="3">Step 4: Repeat Steps 1 through 3 two more times using the same remote fob. You should complete three full cycles total. Remember to complete each step within 5 seconds of the last to maintain system readiness. </font></li> <li><font size="3">Step 5: After the third cycle, turn the ignition switch to the ON (II) position once again. The system is now ready to enter programming mode. </font></li> <li><font size="3">Step 6: Press the LOCK or UNLOCK button on the same remote fob. If successful, the power door locks will cycle (lock and unlock), confirming entry into programming mode. </font></li> <li><font size="3">Step 7: Press the LOCK or UNLOCK button on each remote you wish to program. After pressing each remote, wait for the door locks to cycle to confirm successful registration. You must program all remotes during the same session. Any fob not programmed at this time will be removed from the system and will no longer function. </font></li> <li><font size="3">Step 8: Turn the ignition switch to the LOCK (0) position to exit programming mode. The vehicle will now store all programmed remote data. </font></li> <li><font size="3">Step 9: Remove the key and test each remote. Ensure that locking, unlocking, and any other remote features work correctly. </font></li> </ul> <p><b><font size="3">Important Clarification:</font></b></p> <ul> <li><font size="3"> This procedure programs the remote control functions only. If your key includes a built-in transponder chip or integrated key blade, cutting and programming the ignition portion must be completed separately using the appropriate equipment.</font></li> </ul>
