<h1>Keyless Entry Remote Programming Instructions – 2006 Honda Ridgeline</h1> <p><font size="3"><b>Important:</b> These instructions apply to the remote (keyless entry) portion only. The key or combination key/fob must still be professionally programmed to start the vehicle. To complete this procedure, you must use a fully functional key that can start your Ridgeline. </font></p> <p><font size="3"><b>Step-by-Step Programming Procedure</b> </font></p> <ul> <li><font size="3">Step 1: Insert your working key into the ignition and turn it to the ON position (do not start the engine). </font></li> <li><font size="3">Step 2: Within 1 to 4 seconds, press the LOCK or UNLOCK button on the remote, pointing it toward the instrument panel. </font></li> <li><font size="3">Step 3: Within 1 to 4 seconds, turn the ignition back to the OFF position. </font></li> <li><font size="3">Step 4: Repeat the ON–press button–OFF cycle two more times: Turn ignition to ON Press the LOCK or UNLOCK button Turn ignition to OFF (You will have now completed this sequence three times.) </font></li> <li><font size="3">Step 5: Turn the ignition to the ON position a fourth time. </font></li> <li><font size="3">Step 6: Within 1 to 4 seconds, press the LOCK or UNLOCK button again. At this point, the door locks should cycle automatically, confirming that the system is now in programming mode.</font></li> <li><font size="3"> Step 7: Within 1 to 4 seconds, press the LOCK or UNLOCK button once more on the same remote to begin storing the code. </font></li> <li><font size="3">Step 8: Within 15 seconds, program additional remotes (up to 3 total): For each remote, aim it at the instrument panel and press the LOCK or UNLOCK button. The door locks should cycle after each remote is successfully programmed. </font></li> <li><font size="3">Step 9: Turn the ignition switch to the OFF position and remove the key. Step 10: Test each remote to confirm it operates the locks correctly.</font></li> </ul>
