<h1>Keyless Entry Remote Programming Instructions – 2006 Honda S2000</h1> <p><font size="3"><b>Important Notice:</b> Entering programming mode will erase all previously programmed remotes. To retain full functionality, you must program all remotes during the same session. Each step must be completed within 5 seconds of the last to avoid exiting programming mode. </font></p> <p><font size="3"><b>Step-by-Step Programming Procedure</b> </font></p> <ul> <li><font size="3">Step 1: Insert the key into the ignition and turn it to the ON (II) position. (This is the position just before starting the engine.) </font></li> <li><font size="3">Step 2: Press the LOCK or UNLOCK button on the remote you want to program. A new or unprogrammed remote may be used. </font></li> <li><font size="3">Step 3: Turn the ignition switch to the OFF (0) position. </font></li> <li><font size="3">Step 4: Repeat steps 1 through 3 two more times, for a total of three full ON–press–OFF cycles using the same remote. </font></li> <li><font size="3">Step 5: After the third cycle, turn the ignition switch to the ON (II) position once again. </font></li> <li><font size="3">Step 6: Press the LOCK or UNLOCK button on the same remote. If successful, the door locks will cycle, confirming that the system has entered programming mode. </font></li> <li><font size="3">Step 7: Press the LOCK or UNLOCK button on each additional remote you wish to program. The door locks should cycle after each remote is accepted. </font></li> <li><font size="3">Step 8: Turn the ignition to the OFF (0) position to exit programming mode. </font></li> <li><font size="3">Step 9: Test all remotes to ensure they function properly.</font></li> </ul>
