<h1>Keyless Entry Remote Programming Guide – 2007 Model</h1> <p><font size="3"><b> Important Information:</b> Entering programming mode will erase all previously stored remote codes. All remotes must be reprogrammed during the same session. Each step must be completed within 4 seconds of the previous one to remain in programming mode. Additional remotes must be programmed within 10 seconds of each other. </font></p> <p><font size="3"><b>Step-by-Step Programming Instructions:</b></font></p> <ul> <li><font size="3"> Step 1: Insert the key and turn the ignition switch to the ""ON"" (II) position.</font></li> <li><font size="3"> Step 2: Within 4 seconds, press the lock or unlock button on a remote. (You may use an unprogrammed remote for this step.) </font></li> <li><font size="3">Step 3: Within 4 seconds, turn the ignition switch to the ""OFF"" (0) position. </font></li> <li><font size="3">Step 4: Within 4 seconds, turn the ignition switch to the ""ON"" (II) position, then immediately back to the ""OFF"" position. </font></li> <li><font size="3">Step 5: Repeat Steps 2, 3, and 4 two additional times, using the same remote. </font></li> <li><font size="3">Step 6: Within 4 seconds, press the lock or unlock button on each remote you wish to program. After each press, confirm the door locks cycle to indicate successful programming. </font></li> <li><font size="3">Step 7: Turn the ignition switch to the ""OFF"" (0) position to exit programming mode.</font></li> <li><font size="3"> Step 8: Remove the key and wait approximately 10 seconds. </font></li> <li><font size="3">Step 9: Test all remotes to ensure they function correctly.</font></li> </ul>
