<h1>2007 GMC Yukon – Remote Fob Programming Instructions</h1> <p><font size="3">Depending on the vehicle configuration, follow the correct method below to program your keyless entry remote(s). The process varies based on whether your Yukon is equipped with Driver Information Center (DIC) buttons.</font></p> <p><font size="3"><b> For Vehicles WITH Driver Information Center (DIC) Buttons</b> </font></p> <ul> <li><font size="3">Step 1: Insert the key into the ignition and turn it to the ON position (do not start the engine). </font></li> <li><font size="3">Step 2: Press the vehicle information button repeatedly until the display shows “PRESS TO RELEARN REMOTE KEY.” </font></li> <li><font size="3">Step 3: Press the set/reset button to enter programming mode. The display will read “REMOTE KEY LEARNING ACTIVE.” </font></li> <li><font size="3">Step 4: On the remote, press and hold both the LOCK and UNLOCK buttons simultaneously for approximately 15 seconds. – A chime will sound, confirming the remote has been successfully programmed. </font></li> <li><font size="3">Step 5: To program additional remotes, repeat Step 4 for each one. – You can program up to eight remotes total. </font></li> <li><font size="3">Step 6: Turn the ignition OFF and remove the key to exit programming mode. </font></li> <li><font size="3">Step 7: Test all remotes to verify functionality. </font></li> </ul> <p><font size="3"><b>For Vehicles WITHOUT Driver Information Center (DIC) Buttons</b> </font></p> <p><font size="3">Before starting, ensure the vehicle is in Park and the key is turned to the ON position (as far as it goes without cranking the engine). </font></p> <ul> <li><font size="3">Step 1: Press the trip odometer reset stem repeatedly until the display shows “RELEARN REMOTE KEY.” </font></li> <li><font size="3">Step 2: Press and hold the trip odometer reset stem for approximately three seconds. – The message will update to “REMOTE KEY LEARNING ACTIVE.”</font></li> <li><font size="3"> Step 3: On the first remote, press and hold both the LOCK and UNLOCK buttons at the same time for about 15 seconds. – A chime will sound, confirming successful programming. </font></li> <li><font size="3">Step 4: Repeat Step 3 for any additional remotes, up to a maximum of eight.</font></li> <li><font size="3"> Step 5: Turn the ignition OFF and remove the key to exit programming mode. </font></li> <li><font size="3">Step 6: Test all remotes to ensure they are working correctly.</font></li> </ul>
