<h1>2007 GMC Yukon Denali Keyless Entry Remote Fob (Smart Key)</h1> <p><font size="3"> The 2007 Yukon Denali supports onboard programming for keyless remote fobs. The procedure differs depending on whether your vehicle is equipped with Driver Information Center (DIC) buttons. </font></p> <p><font size="3"><b>If Your Vehicle Has Driver Information Center (DIC) Buttons:</b> </font></p> <ul> <li><font size="3">Step 1: Insert the key into the ignition and turn it to the ON position (do not start the engine). </font></li> <li><font size="3">Step 2: Press the vehicle information button until the message “PRESS TO RELEARN REMOTE KEY” appears in the Driver Information Center. </font></li> <li><font size="3">Step 3: Press the SET/RESET button. The display will change to “REMOTE KEY LEARNING ACTIVE.” </font></li> <li><font size="3">Step 4: Press and hold both the LOCK and UNLOCK buttons on the remote at the same time. – Hold the buttons for about 15 seconds until a chime sounds, confirming the remote has been programmed.</font></li> <li><font size="3"> Step 5: To program additional remotes, repeat Step 4 for each one. – Up to eight remotes can be programmed. </font></li> <li><font size="3">Step 6: Turn the key to the OFF position and remove it from the ignition to exit programming mode.</font></li> <li><font size="3"> Step 7: Test all remotes to verify proper operation. </font></li> </ul> <p><font size="3"><b>If Your Vehicle Does NOT Have DIC Buttons:</b> </font></p> <ul> <li><font size="3">Step 1: Ensure the vehicle is in Park (P) and insert the key into the ignition. Turn it to the ON position (as far as it goes without cranking the engine). </font></li> <li><font size="3">Step 2: Press the trip odometer reset stem repeatedly until “RELEARN REMOTE KEY” appears on the display. </font></li> <li><font size="3">Step 3: Press and hold the trip odometer reset stem for about three seconds. – The message “REMOTE KEY LEARNING ACTIVE” will appear. </font></li> <li><font size="3">Step 4: Press and hold both the LOCK and UNLOCK buttons on the first remote simultaneously. – Hold for approximately 15 seconds until you hear a chime, confirming successful programming. </font></li> <li><font size="3">Step 5: Repeat Step 4 for any additional remotes. – A maximum of eight remotes can be programmed. </font></li> <li><font size="3">Step 6: Turn the key to the OFF position and remove it from the ignition to exit programming mode.</font></li> <li><font size="3"> Step 7: Test each remote to ensure they are working correctly.</font></li> </ul>
