<h1>2007 Honda Accord Keyless Entry Remote Fob Programming Instructions</h1> <p><font size="3"><b> Important Notice:</b> These instructions will only program the remote portion of the key. Entering programming mode will erase all previously programmed remotes, so you will need to reprogram all remotes once in programming mode. Be sure to complete each step within 5 seconds of the previous step to prevent the system from exiting programming mode. <b></b></font></p> <p><font size="3"><b>Programming Procedure:</b> </font></p> <ul> <li><font size="3">Step 1: Turn the ignition switch to the ON (II) position. This will power up the vehicle's electronics without starting the engine. </font></li> <li><font size="3">Step 2: Press the LOCK or UNLOCK button on one of the remotes. (You can use an un-programmed remote for this step.) </font></li> <li><font size="3">Step 3: Turn the ignition switch to the LOCK (0) position. This temporarily powers off the vehicle’s electronics, preparing the system for reprogramming. </font></li> <li><font size="3">Step 4: Repeat Steps 1, 2, and 3 two more times using the same remote as in Step 2. Ensure that each action is completed within 5 seconds to maintain the programming mode. </font></li> <li><font size="3">Step 5: Turn the ignition switch to the ON (II) position once again. The vehicle is now in programming mode. </font></li> <li><font size="3">Step 6: Press the LOCK or UNLOCK button on the same remote used in Step 2. The power door locks should cycle (lock then unlock) to confirm that the vehicle is in programming mode. </font></li> <li><font size="3">Step 7: Press the LOCK or UNLOCK button on each additional remote you wish to program. After each remote button press, the door locks should cycle to confirm the system has accepted the remote. </font></li> <li><font size="3">Step 8: Repeat Step 7 for each additional remote that you need to program. Each press of the remote button will cause the door locks to cycle, confirming successful programming. </font></li> <li><font size="3">Step 9: Once all remotes have been programmed, turn the ignition switch to the LOCK (0) position to exit programming mode. This will finalize the programming process. </font></li> <li><font size="3">Step 10: Test each remote by pressing the LOCK and UNLOCK buttons. The door locks should respond by locking and unlocking, confirming that the remotes are working as expected. </font></li> </ul> <p><b><font size="3">Note:</font></b></p> <ul> <li><font size="3"> These steps will program the remote portion of the key. If you need the key blade portion programmed or cut, please refer to the vehicle’s owner's manual for additional instructions or seek professional assistance.</font></li> </ul>
