<h1>2007 Honda Fit – Keyless Entry Remote Fob Programming Instructions</h1> <p><font size="3"><b>Important Notice:</b> Entering programming mode will erase all previously stored remotes, so every remote you intend to use must be reprogrammed during the same session. The system allows a maximum of three remotes to be programmed. To avoid exiting programming mode prematurely, each step must be completed within five seconds of the previous step. Before starting, ensure that all doors are unlocked. </font></p> <ul> <li><font size="3">Step 1: Sit in the driver’s seat and insert the key into the ignition. Turn the ignition switch to the ON (II) position—this is the position just before the engine starts. Dash lights should come on, but do not start the engine. </font></li> <li><font size="3">Step 2: Press either the LOCK or UNLOCK button on the remote. This begins the remote synchronization process. You may use a previously programmed or unprogrammed remote. </font></li> <li><font size="3">Step 3: Turn the ignition to the ACCESSORY (I) or LOCK (0) position. </font></li> <li><font size="3">Step 4: Turn the ignition switch back to the ON (II) position again.</font></li> <li><font size="3"> Step 5: Press the LOCK or UNLOCK button on the same remote. </font></li> <li><font size="3">Step 6: Turn the ignition back to ACCESSORY (I) or LOCK (0). </font></li> <li><font size="3">Step 7: Turn the ignition to the ON (II) position once more. </font></li> <li><font size="3">Step 8: Press the LOCK or UNLOCK button again on the remote. </font></li> <li><font size="3">Step 9: Turn the ignition to ACCESSORY (I) or LOCK (0). </font></li> <li><font size="3">Step 10: Now turn the ignition to the ON (II) position for the fourth and final time in this sequence.</font></li> <li><font size="3"> Step 11: Press the LOCK or UNLOCK button again on the same remote. At this point, the door locks should automatically cycle (lock then unlock), confirming that the vehicle is in programming mode. </font></li> <li><font size="3">Step 12: Within five seconds of the lock cycle, press the LOCK or UNLOCK button on each additional remote you wish to program (up to a total of three remotes). The door locks should cycle after each successful registration.</font></li> <li><font size="3"> Step 13: Once all remotes are programmed, turn the ignition switch to the LOCK (0) position to exit programming mode. </font></li> <li><font size="3">Step 14: Remove the key from the ignition and test each remote. Ensure all programmed remotes can successfully lock and unlock the vehicle doors.</font></li> </ul>
