<h1>Keyless Entry Remote Programming Instructions – 2007 Honda S2000</h1> <p><font size="3"><b> Important Notice:</b> Entering programming mode will erase all previously stored remotes. You must reprogram all remotes you intend to use during the same session. To keep the system in programming mode, each step must be completed within 5 seconds of the previous one. </font></p> <p><font size="3"><b>Step-by-Step Programming Procedure</b> </font></p> <ul> <li><font size="3">Step 1: Insert the key into the ignition and turn it to the ON (II) position. (This is the position just before the engine starts.) </font></li> <li><font size="3">Step 2: Press the LOCK or UNLOCK button on the remote you are programming. This step can be done with a new or previously unprogrammed remote. </font></li> <li><font size="3">Step 3: Turn the ignition switch back to the OFF (0) position. </font></li> <li><font size="3">Step 4: Repeat steps 1 through 3 two additional times using the same remote. (You will complete three full ON–press–OFF cycles.) </font></li> <li><font size="3">Step 5: After the third cycle, turn the ignition switch to the ON (II) position again. </font></li> <li><font size="3">Step 6: Press the LOCK or UNLOCK button once more on the same remote. The door locks should cycle, indicating the vehicle has entered programming mode. </font></li> <li><font size="3">Step 7: Press the LOCK or UNLOCK button on each additional remote you wish to program. The door locks should cycle after each successful remote is accepted. </font></li> <li><font size="3">Step 8: Turn the ignition to the OFF (0) position to exit programming mode. </font></li> <li><font size="3">Step 9: Test all remotes to confirm they are functioning correctly.</font></li> </ul>
