<h1>2007 Lincoln Mark LT Keyless Entry Remote Fob</h1> <p><font size="3"><b>Important:</b> The 2007 Lincoln Mark LT supports onboard programming for keyless entry remotes. You can program up to four remotes in the same session. Ensure all remotes are available before starting, as any not included will be erased from the system. </font></p> <p><font size="3"><b>Step-by-Step Programming Instructions:</b> </font></p> <ul> <li><font size="3">Step 1: Make sure all vehicle doors are closed. Then, open the driver’s door and press the UNLOCK button on the driver’s interior door panel. </font></li> <li><font size="3">Step 2: Insert the key into the ignition. </font></li> <li><font size="3">Step 3: Turn the ignition from the OFF position to the RUN position (do not start the engine) eight times within 10 seconds, ending on the eighth turn in the RUN position. ? If successful, the door locks will cycle (lock and unlock) to confirm that the vehicle has entered programming mode. </font></li> <li><font size="3">Step 4: Within 20 seconds, press any button on the first remote fob you want to program. ? The door locks will cycle to confirm that the remote has been successfully programmed. </font></li> <li><font size="3">Step 5: If you have a second remote, press any button on it within 20 seconds of programming the first. ? The locks will cycle again to confirm programming. </font></li> <li><font size="3">Step 6: Repeat Step 5 for any additional remotes (up to a total of four). </font></li> <li><font size="3">Step 7: Turn the ignition to the OFF position to exit programming mode. ? The door locks will cycle once more to confirm the end of programming. </font></li> <li><font size="3">Step 8: Remove the key from the ignition and close the driver’s door. </font></li> <li><font size="3">Step 9: Test each programmed remote to ensure all functions, including lock, unlock, and panic features (if applicable), are working properly.</font></li> </ul>
