2007 Mitsubishi Raider

2007 Mitsubishi Raider – Keyless Entry Remote Fob & Transponder Key Programming Instructions

A. Keyless Entry Remote Fob Programming

Important Notice: This procedure requires at least one working remote fob. If no functional remote is available, this process cannot be completed using onboard steps. All remote fobs must be present during programming, as any not included will become inactive. Preparation: Ensure all remotes (new and working) are in the vehicle. Sit in the driver’s seat with the seatbelt fastened and all doors closed. Make sure no other passengers are inside the vehicle.

Programming Steps:

  • Step 1: Insert the key into the ignition and turn it to the “ON” position (as far as it goes without starting the engine).
  • Step 2: Using a working remote, press and hold the UNLOCK button.
  • Step 3: After holding UNLOCK for at least 4 seconds, press and hold the PANIC button while still holding UNLOCK. Do this within 6 seconds of pressing UNLOCK.
  • Step 4: When an audible chime is heard, the vehicle has entered programming mode. Release both buttons.
  • Step 5: Within 60 seconds, for each remote to be programmed (including working ones), follow this sequence: Press LOCK and UNLOCK simultaneously for 2 seconds Release both buttons Wait for an audible tone Within 4 seconds, press and release the UNLOCK button Wait for another audible tone confirming successful programming
  • Step 6: Repeat Step 5 for all remotes.
  • Step 7: Turn the ignition to the “OFF” position or wait 60 seconds to exit programming mode.
  • Step 8: Test each remote to confirm proper operation.

Note: A maximum of 6 remote fobs can be programmed for this vehicle. B. Transponder Key Programming Important Notice: This procedure requires two working, programmed transponder keys. If fewer than two are available, onboard programming cannot be completed.

Programming Steps:

  • Step 1: Insert the first working key into the ignition. Turn it to the “ON” position (do not start the engine), wait for 3 seconds, then turn it to “OFF” and remove the key.
  • Step 2: Within 15 seconds, insert the second working key. Turn it to the “ON” position and wait approximately 10 seconds. The immobilizer warning light will illuminate and an audible chime will sound. Turn the ignition to “OFF” and remove the key.
  • Step 3: Within 50 seconds, insert the new, unprogrammed key into the ignition. Turn it to the “ON” position. After about 10 seconds, a chime will sound and the immobilizer light will remain on for 3 seconds, confirming successful programming.
  • Step 4: To program additional transponder keys, repeat Steps 1 through 3 for each one.