<h1>Keyless Entry Remote Programming Instructions – 2007 Saturn Outlook</h1> <p><b>Important Notice:</b> The 2007 Saturn Outlook supports onboard programming for keyless entry remote fobs. The procedure differs slightly depending on whether the vehicle is equipped with Driver Information Center (DIC) buttons.</p> <p><b> If Your Vehicle Has Driver Information Center (DIC) Buttons:</b></p> <ul> <li>Step 1: Turn the Ignition to the ON Position Insert the key and turn it to the ON position (do not start the engine). This allows access to the vehicle’s Driver Information Center.</li> <li>Step 2: Navigate to Remote Key Relearn Mode Press the vehicle information button repeatedly until you see the message: “PRESS TO RELEARN REMOTE KEY.”</li> <li>Step 3: Activate Programming Mode Press the Set/Reset button. The display should read: “REMOTE KEY LEARNING ACTIVE.”</li> <li>Step 4: Program the First Remote Press and hold the Lock and Unlock buttons on the first keyless remote at the same time. Hold for about 15 seconds until you hear a chime. This indicates that the remote has been successfully programmed.</li> <li>Step 5: Program Additional Remotes (If Needed) Repeat Step 4 for each additional remote. The vehicle can store up to eight remotes total.</li> <li>Step 6: Exit Programming Mode Turn the ignition to the OFF position and remove the key. Test each remote to ensure full functionality.</li> </ul> <p><b>If Your Vehicle Does NOT Have Driver Information Center Buttons:</b></p> <ul> <li>Step 1: Prepare the Vehicle Ensure the gear selector is in Park (P). Insert the key and turn it to the ON position (as far as it goes without starting the engine).</li> <li>Step 2: Access Remote Key Relearn Mode Press the Trip Odometer Reset Stem until the message “RELEARN REMOTE KEY” appears in the display.</li> <li>Step 3: Activate Programming Mode Press and hold the Trip Odometer Reset Stem for about 3 seconds. You should see: “REMOTE KEY LEARNING ACTIVE.”</li> <li>Step 4: Program the First Remote Press and hold the Lock and Unlock buttons on the first keyless remote simultaneously for approximately 15 seconds. A chime will sound to confirm successful programming.</li> <li>Step 5: Program Additional Remotes (If Needed) Repeat Step 4 for each remote you wish to program. Up to eight remotes can be paired with the vehicle.</li> <li>Step 6: Exit Programming Mode Turn the key to the OFF position and remove it from the ignition. Test all remotes to confirm proper operation.</li> </ul>
