2007 Toyota 4Runner

2007 Toyota 4Runner Keyless Entry Remote Fob Programming Instructions

For Vehicles Equipped with Factory Keyless Entry System

Important Note: This procedure allows you to program new remote fobs. Timing is critical—each step must be performed within the specified window, or the process will need to be restarted.

Step-by-Step Procedure:

  • Step 1: Vehicle Setup Remove the key from the ignition. Ensure the driver’s door is open and unlocked. All other doors should remain closed.
  • Step 2: Key Insertion (within 5 seconds)
  • A) Insert the key into the ignition without turning it, then remove it.
  • B) Repeat: Insert the key again (do not turn), then remove it.
  • Step 3: Door Operation (within 40 seconds)
  • A) Close and reopen the driver’s door.
  • B) Close and reopen the driver’s door again.
  • C) Insert the key into the ignition (do not turn), then remove it.
  • Step 4: Final Setup (within 40 seconds)
  • A) Close and reopen the driver’s door.
  • B) Repeat: close and reopen the door once more.
  • C) Insert the key into the ignition and leave it in place.
  • D) Close the driver’s door.
  • E) Turn the ignition to the ON position (do not start the engine), then back to OFF.
  • F) Remove the key from the ignition.
  • Step 5: Confirm Programming Mode Within 3 seconds, the door locks should automatically lock and then unlock, confirming the system is ready to program remotes. If the locks do not cycle, restart the procedure from Step 1.
  • Step 6: Program Remote(s) (within 40 seconds)
  • A) Press and hold the LOCK and UNLOCK buttons on the remote simultaneously for 1.5 seconds.
  • B) Release both buttons, then press and hold the LOCK button alone for 2 seconds. If the door locks lock and unlock once, the remote has been successfully programmed. If the locks cycle twice, the programming failed—repeat Step 6A and 6B.
  • C) Repeat this step for each additional remote you wish to program.
  • Step 7: Exit Programming Mode Open the driver’s door to end the programming session. Test all remotes to confirm that they function correctly.