<h1>Keyless Entry Remote Programming Guide – 2008 TL</h1> <p><font size="3"><b> Important Information:</b> Entering programming mode will erase all previously stored remote codes. All remotes must be reprogrammed during the same session. Each step must be completed within 4 seconds of the previous one to maintain programming mode. Additional remotes must be programmed within 10 seconds of each other. </font></p> <p><font size="3"><b>Step-by-Step Programming Instructions:</b> </font></p> <ul> <li><font size="3">Step 1: Insert the key and turn the ignition switch to the ""ON"" (II) position. </font></li> <li><font size="3">Step 2: Within 4 seconds, press the lock or unlock button on a remote. (An unprogrammed remote may be used.) </font></li> <li><font size="3">Step 3: Within 4 seconds, turn the ignition switch to the ""OFF"" (0) position. </font></li> <li><font size="3">Step 4: Within 4 seconds, turn the ignition switch to the ""ON"" (II) position, then immediately back to ""OFF."" </font></li> <li><font size="3">Step 5: Repeat Steps 2, 3, and 4 two more times using the same remote. This completes a total of three cycles. </font></li> <li><font size="3">Step 6: Within 4 seconds, press the lock or unlock button on each additional remote you wish to program. Wait for the door locks to cycle after each press to confirm successful programming. </font></li> <li><font size="3">Step 7: Turn the ignition switch to the ""OFF"" (0) position to exit programming mode.</font></li> <li><font size="3"> Step 8: Remove the key, wait approximately 10 seconds, then test all remotes to confirm proper operation.</font></li> </ul>
