<h1>2008 Honda Fit – Keyless Entry Remote Fob Programming Instructions</h1> <p><font size="3"><b> Important Notice:</b> When entering programming mode, all previously stored keyless remotes will be erased. You must reprogram all remotes during the same session, or they will no longer function. A maximum of three remote transmitters can be programmed. Ensure all doors are unlocked before starting. Each step must be completed within five seconds of the previous to prevent the system from exiting programming mode. </font></p> <ul> <li><font size="3">Step 1: Sit in the driver’s seat and insert the key into the ignition. Turn the ignition switch to the ON (II) position. Do not start the engine—just turn the key until the dash lights come on. </font></li> <li><font size="3">Step 2: Press the LOCK or UNLOCK button on the remote you wish to program. This can be a new or previously used remote. </font></li> <li><font size="3">Step 3: Turn the ignition to the ACCESSORY (I) or LOCK (0) position. </font></li> <li><font size="3">Step 4: Turn the ignition switch back to the ON (II) position. </font></li> <li><font size="3">Step 5: Press the LOCK or UNLOCK button on the same remote again. </font></li> <li><font size="3">Step 6: Turn the ignition switch back to the ACCESSORY (I) or LOCK (0) position. </font></li> <li><font size="3">Step 7: Turn the ignition to the ON (II) position again. </font></li> <li><font size="3">Step 8: Press the LOCK or UNLOCK button once more on the remote. </font></li> <li><font size="3">Step 9: Turn the ignition to the ACCESSORY (I) or LOCK (0) position. </font></li> <li><font size="3">Step 10: Turn the ignition back to the ON (II) position for the final time. </font></li> <li><font size="3">Step 11: Press the LOCK or UNLOCK button on the same remote one more time. The power door locks should cycle automatically (lock and unlock), confirming that the vehicle has entered programming mode. </font></li> <li><font size="3">Step 12: Within five seconds of the lock cycle, press the LOCK or UNLOCK button on each additional remote you wish to program. The door locks will cycle after each successful programming to confirm the system has accepted the remote. </font></li> <li><font size="3">Step 13: When all remotes have been programmed, turn the ignition to the LOCK (0) position to exit programming mode. </font></li> <li><font size="3">Step 14: Remove the key and test all programmed remotes to verify that they lock and unlock the doors as expected.</font></li> </ul>
