<h1>Programming Guide for 2008 Honda S2000 Keyless Entry Remote Fob</h1> <p><b>Important Notice:</b> The 2008 Honda S2000 may be equipped with either a dealer-installed or factory-installed keyless entry system. Each version has a separate programming method. Entering programming mode will erase all previously stored remotes. Be sure to program all remotes during the same session. Dealer-Installed Keyless Entry System</p> <p><b>Programming Steps:</b></p> <p>Step 1: Turn the ignition to the ON (II) position (do not start the engine).</p> <p>Step 2: Press either the LOCK or UNLOCK button on one of the remotes. This remote can be previously programmed or new.</p> <p>Step 3: Turn the ignition to the LOCK (0) position.</p> <p>Step 4: Repeat Steps 1–3 two more times using the same remote (total of 3 cycles).</p> <p>Step 5: Turn the ignition to the ON (II) position a fourth time.</p> <p>Step 6: Press the LOCK or UNLOCK button again on the same remote. The power door locks should cycle to indicate the system is now in programming mode.</p> <p>Step 7: Press the LOCK or UNLOCK button on each remote you wish to program. After each button press, the door locks should cycle, confirming successful programming.</p> <p>Step 8: Turn the ignition to LOCK (0) to exit programming mode.</p> <p>Step 9: Test all programmed remotes to confirm functionality. Factory-Installed Keyless Entry System Maximum of three remotes can be programmed. Programming a fourth will erase the first.</p> <p><b>Programming Steps:</b></p> <p>Step 1: Turn the ignition to the ON (II) position.</p> <p>Step 2: Within 4 seconds, press the LOCK or UNLOCK button on the remote while pointing it toward the receiver near the glove box.</p> <p>Step 3: Within 4 seconds, turn the ignition to the LOCK (0) position.</p> <p>Step 4: Repeat Steps 1–3 two more times using the same remote (total of 3 cycles).</p> <p>Step 5: Turn the ignition to the ON (II) position again.</p> <p>Step 6: Within 4 seconds, press the LOCK or UNLOCK button on the same remote. The door locks should cycle to confirm programming mode. Press the LOCK or UNLOCK button again to continue.</p> <p>Step 7: Press the LOCK or UNLOCK button on each additional remote. Ensure the door locks cycle each time to confirm each remote is accepted.</p> <p>Step 8: Turn the ignition to the LOCK (0) position to exit programming mode.</p> <p>Step 9: Test all remotes to ensure they function correctly.</p> <p><b>Final Tips:</b> Complete each step quickly (within the time limits) or the system may exit programming mode. If the door locks do not cycle, restart the procedure from the beginning. Test all functions (lock, unlock, trunk) after programming. "</p>
