<h1>2008 Lincoln Mark LT Keyless Entry Remote Fob</h1> <p><font size="3"><b> Important:</b> The 2008 Lincoln Mark LT supports onboard programming for keyless entry remote fobs. Up to four remotes can be programmed during a single session. Any remote not included during programming will be erased and must be reprogrammed. </font></p> <p><font size="3"><b>Step-by-Step Programming Instructions:</b> </font></p> <ul> <li><font size="3">Step 1: Close all vehicle doors. Then, open the driver’s door and press the UNLOCK button on the interior driver’s door panel. </font></li> <li><font size="3">Step 2: Insert the ignition key into the ignition cylinder. </font></li> <li><font size="3">Step 3: Turn the ignition from the OFF position to the RUN position (do not start the engine) eight times within 10 seconds, ending in the RUN position on the eighth turn. If done correctly, the door locks will cycle (lock and unlock) to confirm that the vehicle has entered programming mode. </font></li> <li><font size="3">Step 4: Within 20 seconds, press any button on the first keyless remote fob you wish to program. The door locks will cycle again to confirm successful programming. </font></li> <li><font size="3">Step 5: Within 20 seconds, press any button on the second remote (if applicable). The door locks will cycle once more to confirm programming. </font></li> <li><font size="3">Step 6: Repeat Step 5 for any additional remotes, up to four total. </font></li> <li><font size="3">Step 7: Turn the ignition to the OFF position to exit programming mode. The door locks will cycle a final time, confirming that programming mode has ended. </font></li> <li><font size="3">Step 8: Remove the key from the ignition and close the driver’s door. </font></li> <li><font size="3">Step 9: Test all remotes to ensure that lock, unlock, and other features (such as panic or trunk release) are working correctly.</font></li> </ul>
