<h1>Keyless Entry Remote Programming – 2008 Saturn Sky</h1> <p><font size="3"><b>Important Notice:</b> The 2008 Saturn Sky does not support onboard programming for keyless entry remote fobs. Programming must be performed using advanced diagnostic equipment by a trained automotive technician or service provider. </font></p> <p><font size="3"><b>Step-by-Step Programming Instructions:</b> </font></p> <ul> <li><font size="3">Step 1: Schedule Service with a Qualified Technician Locate a professional automotive technician or service center equipped with the appropriate diagnostic tools required to program keyless remote fobs for this vehicle. </font></li> <li><font size="3">Step 2: Bring All Remotes to Be Programmed Make sure to bring all remote fobs with you. During the programming process, any remotes not present will be erased from the vehicle’s memory and will need to be reprogrammed later to function. </font></li> <li><font size="3">Step 3: Drive to the Service Location if Possible If your vehicle is operational, driving it to the technician’s location may reduce service costs compared to requesting on-site assistance. </font></li> <li><font size="3">Step 4: Prepare Proof of Ownership Be ready to show documentation such as your vehicle registration or title and a government-issued photo ID. This is commonly required to authorize programming procedures. </font></li> <li><font size="3">Step 5: Technician Connects Diagnostic Equipment The technician will connect a scan tool to the vehicle’s OBD-II port, allowing access to the vehicle’s control systems for remote programming. </font></li> <li><font size="3">Step 6: Activate Programming Mode Through the diagnostic interface, the technician will enter programming mode and begin registering each remote individually. </font></li> <li><font size="3">Step 7: Program and Verify Functionality Each remote is programmed and tested to ensure it correctly controls functions such as lock, unlock, and panic. Adjustments are made if needed. </font></li> <li><font size="3">Step 8: Exit Programming and Confirm Completion After programming all remotes, the technician will finalize the session and disconnect the diagnostic equipment. </font></li> <li><font size="3">Step 9: Test All Remotes Before concluding the visit, confirm that all remote fobs operate correctly with the vehicle.</font></li> </ul>
