2008 Scion xD

2008 Scion xD Smart Key Remote Fob Programming Instructions

Important Note: These steps apply to programming the remote (keyless entry) portion of the Remote Head Key. If your vehicle uses a transponder key system, the key blade must be cut and programmed by a qualified technician. If your vehicle uses a non-transponder key, the key only needs to be cut—no additional programming is required for the ignition portion.

Step-by-Step Programming Instructions (Remote Function Only):

  • Step 1: Ensure the key is completely removed from the ignition.
  • Step 2: Open and unlock the driver’s door manually. Make sure all other doors—including the trunk—are closed.
  • Step 3: Within 5 seconds, insert the key into the ignition and remove it twice in quick succession.
  • Step 4: Close the driver’s door, then open it again twice.
  • Step 5: Insert the key into the ignition again and remove it.
  • Step 6: Close the driver’s door, then open it again twice.
  • Step 7: Insert the key into the ignition and leave it in place.
  • Step 8: Close the driver’s door.
  • Step 9: Turn the ignition switch to the ON position (do not start the engine), then turn it OFF.
  • Step 10: Remove the key from the ignition.
  • Step 11: The door locks will cycle (lock and unlock) to confirm that the vehicle has successfully entered remote programming mode.
  • Step 12: On the first remote to be programmed, press and hold both the LOCK and UNLOCK buttons simultaneously for 1.5 seconds, then release.
  • Step 13: Immediately press and hold the LOCK button for 2 seconds, then release.
  • Step 14: The door locks will cycle again to confirm the remote was successfully registered. If you have additional remotes to program, repeat Steps 12–13 for each one within the same session. If you are done programming remotes, proceed to Step 15.
  • Step 15: Open the driver’s door to exit programming mode. The process is now complete.