2008 Suzuki XL7

2008 Suzuki XL7 Keyless Entry Remote Fob Programming Instructions

For Vehicles with Driver Information Center (DIC)

Important Note: These instructions apply to models equipped with a Driver Information Center. The vehicle can store up to eight remote fobs. Follow the steps below to program one or more remotes.

Step-by-Step Procedure:

  • Step 1: Insert the key into the ignition and turn it to the ON position (do not start the engine). This will activate the Driver Information Center (DIC) display.
  • Step 2: Press the vehicle information button repeatedly until the message “PRESS TO RELEARN REMOTE KEY” appears on the display screen.
  • Step 3: Press the set/reset button. The display will change to “REMOTE KEY LEARNING ACTIVE,” indicating that the system is ready to program remotes.
  • Step 4: Take the first remote and press and hold both the LOCK and UNLOCK buttons at the same time. Hold for approximately 15 seconds until a chime sounds, confirming that the remote has been successfully programmed.
  • Step 5: To program additional remotes, repeat Step 4 for each one. You can program up to eight remotes total during this session.
  • Step 6: Once all remotes are programmed, turn the key to the OFF position and remove it from the ignition to exit programming mode.
  • Step 7: Test each remote to ensure all functions are working correctly.