Keyless Entry Remote Fob Programming Instructions for the 2008 Toyota Matrix

Important Notice: The 2008 Toyota Matrix allows onboard programming for keyless entry remote fobs. Follow the steps below exactly to enter programming mode and successfully pair your remote(s).

Programming Procedure:

• Step 1: Begin with the key completely out of the ignition. Make sure the driver’s door is open, all other doors are closed, and the driver’s door is unlocked.
• Step 2: Within 5 seconds, complete the following actions: Insert the key into the ignition (do not turn), then remove it. Insert the key again (do not turn), then remove it.
• Step 3: Within 40 seconds, perform this sequence: Close and then open the driver’s door. Close and then open the driver’s door again. Insert the key into the ignition (do not turn), then remove it.
• Step 4: Within the next 40 seconds, continue with these actions: Close and then open the driver’s door. Close and then open the driver’s door again. Insert the key into the ignition and leave it inserted. Close the driver’s door. Turn the ignition to the ON position (do not start the engine), then turn it back to OFF. Remove the key from the ignition.
• Step 5: Within 3 seconds, the power door locks should automatically cycle—locking and unlocking once. This confirms entry into programming mode. If the locks do not cycle, repeat the process starting from Step 1.
• Step 6: Within 40 seconds, program the remote as follows: Press and hold both the LOCK and UNLOCK buttons on the remote simultaneously for 1.5 seconds. Release both buttons, then press and hold the LOCK button for 2 seconds. If the door locks cycle once, the remote has been successfully programmed. If the locks cycle twice, the remote was not accepted. Repeat Step 6.
• Step 7: Repeat Step 6 for any additional remotes you wish to program (up to four total).
• Step 8: Open the driver’s door to exit programming mode.