2008 Toyota Yaris

2008 Toyota Yaris Keyless Entry Remote Fob

Programming Instructions: These instructions are specifically for programming the remote portion of a Key/Remote combo. Note that if the key portion requires a transponder chip, it will still need to be cut and programmed separately.

Follow these steps carefully:

  • Step 1: Ensure the driver’s door is open and unlocked, with the key removed from the ignition.
  • Step 2: Insert the key into the ignition and remove it twice within 5 seconds.
  • Step 3: Close and then open the driver's door twice within 40 seconds.
  • Step 4: Insert the key into the ignition and then remove it.
  • Step 5: Again, close and open the driver's door twice within 40 seconds.
  • Step 6: Insert the key into the ignition.
  • Step 7: Close the driver’s door.
  • Step 8: Turn the ignition switch from ""LOCK"" to ""ON"" and back to ""LOCK"": Turn to ""ON"" and back to ""LOCK"" once to enter ADD mode (if you are adding a new remote). Turn to ""ON"" and back to ""LOCK"" twice to enter REWRITE mode (if you are replacing all remotes).
  • Step 9: Remove the key from the ignition.
  • Step 10: The power locks will now cycle from ""lock"" to ""unlock"" the number of times corresponding to your selection in step 8 to confirm the mode.
  • Step 11: Within 40 seconds of the locks cycling: Press both the Lock and Unlock buttons on the transmitter simultaneously. Within 3 seconds, press the Lock button on the transmitter for more than 1 second. If successful, the power locks will cycle once to indicate successful programming (if the locks cycle twice, it indicates a problem with the transmitter). Repeat this step for each additional remote you wish to program.
  • Step 12: Open the driver's door to exit the programming mode.