<h1>2009 GMC Savana Remote Fob Programming Instructions</h1> <p><font size="3">Depending on the vehicle’s configuration, follow the appropriate steps below. One method applies to models equipped with Driver Information Center (DIC) buttons, and the other is for those without them. </font></p> <p><b><font size="3">Procedure for Vehicles WITH Driver Information Center (DIC) Buttons:</font></b></p> <ul> <li><font size="3">Step 1: Insert the key into the ignition and turn it to the ON position (do not start the engine). </font></li> <li><font size="3">Step 2: Press the vehicle information button repeatedly until the message “PRESS TO RELEARN REMOTE KEY” appears on the display. </font></li> <li><font size="3">Step 3: Press the set/reset button to activate programming mode. The screen should now display “REMOTE KEY LEARNING ACTIVE.” </font></li> <li><font size="3">Step 4: On the first remote fob, press and hold the lock and unlock buttons at the same time. Hold both buttons for about 15 seconds until you hear a chime, confirming that the remote has been successfully programmed. </font></li> <li><font size="3">Step 5: To program additional remotes, repeat Step 4 for each one. Up to eight remotes can be programmed to the vehicle. </font></li> <li><font size="3">Step 6: Turn the ignition OFF, remove the key, and test each remote to verify proper operation. </font></li> </ul> <p><b><font size="3">Procedure for Vehicles WITHOUT Driver Information Center (DIC) Buttons:</font></b></p> <p><font size="3">Ensure the vehicle is in Park, and turn the ignition to the ON position (the last position before the engine cranks). </font></p> <ul> <li><font size="3">Step 1: Press the trip odometer reset stem repeatedly until the message “RELEARN REMOTE KEY” appears on the instrument panel. </font></li> <li><font size="3">Step 2: Press and hold the trip odometer reset stem for about 3 seconds until the message changes to “REMOTE KEY LEARNING ACTIVE.” </font></li> <li><font size="3">Step 3: On the first remote, press and hold the lock and unlock buttons simultaneously for approximately 15 seconds, until you hear a chime. This sound confirms the remote has been stored successfully. </font></li> <li><font size="3">Step 4: Repeat Step 3 for any additional remotes you want to program, up to a maximum of eight. </font></li> <li><font size="3">Step 5: Exit programming mode by turning the ignition OFF and removing the key. Test each remote to confirm proper functionality.</font></li> </ul>
