<h1>2009 Honda Accord Keyless Entry Remote Fob Programming Instructions</h1> <p><font size="3"><b>Important Notice:</b> These instructions will only program the remote portion of the key. Entering programming mode will erase all previously programmed remotes, so you will need to reprogram all remotes. Be sure to complete each step within 5 seconds of the previous one to prevent the system from exiting programming mode prematurely.</font></p> <p><font size="3"> <b>Programming Procedure:</b> </font></p> <ul> <li><font size="3">Step 1: Turn the ignition switch to the ON (II) position. This powers up the vehicle’s electronics without starting the engine. </font></li> <li><font size="3">Step 2: Press the LOCK or UNLOCK button on one of the remotes. (You may use an un-programmed remote for this step.) </font></li> <li><font size="3">Step 3: Turn the ignition switch to the LOCK (0) position. This temporarily powers off the vehicle’s electronics to prepare it for programming. </font></li> <li><font size="3">Step 4: Repeat Steps 1, 2, and 3 two more times, using the same remote you used in Step 2. Ensure each step is done quickly, within 5 seconds, to maintain the programming mode.</font></li> <li><font size="3"> Step 5: Turn the ignition switch to the ON (II) position again. This puts the vehicle into programming mode. </font></li> <li><font size="3">Step 6: Press the LOCK or UNLOCK button on the same remote used in Step 2. The power door locks should cycle (lock and unlock) to confirm that the vehicle is now in programming mode. </font></li> <li><font size="3">Step 7: Press the LOCK or UNLOCK button on each remote you wish to program. After pressing each remote’s button, the door locks should cycle again to confirm the system has successfully accepted the remote. </font></li> <li><font size="3">Step 8: Repeat Step 7 for each additional remote you need to program. The door locks will cycle after each remote button press, confirming that the remote is programmed successfully.</font></li> <li><font size="3"> Step 9: Once all remotes are programmed, turn the ignition switch to the LOCK (0) position to exit programming mode. This saves the programming and prevents any further remotes from being added.</font></li> <li><font size="3"> Step 10: Test each remote by pressing the LOCK and UNLOCK buttons. The door locks should respond by locking and unlocking, confirming that the remotes are functioning properly. </font></li> </ul> <p><font size="3"><b>Note:</b> </font></p> <ul> <li><font size="3">Remote Head Key Programming: These steps will program the remote portion of the key. If you need to program the key blade portion, refer to your vehicle’s owner’s manual for additional instructions on key cutting and programming. If you have one working key, you can use a programming tool to program a spare key. Additional instructions for using a programmer tool are available in your vehicle’s manual or through the vehicle’s manufacturer.</font></li> </ul>
