<h1>2009 Honda Element – Keyless Entry Remote Fob Programming Instructions</h1> <p><font size="3"><b> Important Notice:</b> Activating the programming mode will erase all existing remote fob codes from the vehicle’s memory. You must reprogram every remote you intend to use during this session. To remain in programming mode, you must perform each step within 5 seconds of the previous one. </font></p> <ul> <li><font size="3">Step 1: Sit in the driver’s seat with all doors closed and unlocked. Ensure you have all the remotes you want to program with you before beginning the process. </font></li> <li><font size="3">Step 2: Insert the key into the ignition and turn it to the ON (II) position. This is the position right before starting the engine—dash lights should illuminate, but the engine must remain off.</font></li> <li><font size="3"> Step 3: Within five seconds, press either the LOCK or UNLOCK button on the remote you want to program. You may use either a new remote or one previously programmed to the vehicle. </font></li> <li><font size="3">Step 4: Turn the ignition back to the LOCK (0) position. This completes one programming cycle. </font></li> <li><font size="3">Step 5: Repeat Steps 2 through 4 two additional times, for a total of three complete cycles. Each cycle should be completed quickly and within five seconds per step to maintain synchronization with the system. </font></li> <li><font size="3">Step 6: After the third cycle, turn the ignition to the ON (II) position again. You have now entered the vehicle’s programming mode. </font></li> <li><font size="3">Step 7: Press the LOCK or UNLOCK button on the same remote again. If the door locks cycle automatically (lock then unlock), this confirms the vehicle has accepted the remote and is in programming mode. </font></li> <li><font size="3">Step 8: Within five seconds, press the LOCK or UNLOCK button on each additional remote you wish to program. After pressing the button, wait for the door locks to cycle before continuing to the next remote. </font></li> <li><font size="3">Step 9: Repeat Step 8 until all remotes have been programmed. If the door locks fail to cycle, the remote may not have been accepted and the process should be restarted. </font></li> <li><font size="3">Step 10: When finished, turn the ignition switch back to the LOCK (0) position to exit programming mode. </font></li> <li><font size="3">Step 11: Remove the key from the ignition and test each remote by locking and unlocking the vehicle doors. Ensure all remotes function properly before completing the process.</font></li> <li><font size="3"> Step 12: If a remote fails to operate or the locks do not cycle during programming, repeat the process from Step 1. Precise timing and accurate steps are essential for successful programming.</font></li> </ul>
