<h1>Keyless Entry Remote Programming – 2009 Saturn Outlook</h1> <p><b>Important Notice:</b> The 2009 Saturn Outlook supports onboard programming for keyless entry remotes. The programming method depends on whether your vehicle is equipped with Driver Information Center (DIC) buttons or not.</p> <p><b>For Vehicles with Driver Information Center (DIC) Buttons:</b></p> <ul> <li>Step 1: Turn the Ignition to ON Insert the key into the ignition and turn it to the ON position (do not start the engine). This will activate the Driver Information Center display.</li> <li>Step 2: Navigate to Remote Learning Mode Press the Vehicle Information button repeatedly until the message “PRESS TO RELEARN REMOTE KEY” appears.</li> <li>Step 3: Activate Programming Mode Press the Set/Reset button. The display will change to “REMOTE KEY LEARNING ACTIVE.”</li> <li>Step 4: Program the First Remote Press and hold the Lock and Unlock buttons on the first remote at the same time. Hold for about 15 seconds until you hear a chime confirming that the remote has been successfully programmed.</li> <li>Step 5: Program Additional Remotes (if needed) Repeat Step 4 for each additional remote. The vehicle can support up to eight remotes in total.</li> <li>Step 6: Exit Programming Mode Turn the ignition OFF and remove the key. Test each remote to ensure proper operation.</li> </ul> <p><b>For Vehicles Without Driver Information Center Buttons:</b></p> <ul> <li>Step 1: Prepare the Vehicle Ensure the vehicle is in Park (P). Insert the key and turn it to the ON position (do not start the engine).</li> <li>Step 2: Access Remote Programming Option Press the Trip Odometer Reset Stem repeatedly until the message “RELEARN REMOTE KEY” appears in the display.</li> <li>Step 3: Activate Learning Mode Press and hold the Trip Odometer Reset Stem for approximately 3 seconds. The display will show “REMOTE KEY LEARNING ACTIVE.”</li> <li>Step 4: Program the First Remote Press and hold the Lock and Unlock buttons on the remote at the same time for about 15 seconds. A chime will sound to confirm successful programming.</li> <li>Step 5: Program Additional Remotes (if needed) Repeat Step 4 for any other remotes you wish to add. The system can store up to eight remotes.</li> <li>Step 6: Complete the Process Turn the ignition OFF and remove the key. Test all remotes to confirm they function as expected.</li> </ul>
