2009 Toyota Tacoma

2009 Toyota Tacoma Smart Key Remote Fob Programming Guide

Important Notice: This programming procedure applies only to vehicles equipped with a factory-installed keyless entry system. Timing is critical—each step must be completed within the specified time to successfully program remote fobs.

Programming Procedure

  • Step 1: Vehicle Setup Make sure the key is removed from the ignition. The driver’s door must be open and unlocked. All other doors should remain closed during the process.
  • Step 2: Initial Key Insertions – Complete Within 5 Seconds A. Insert the key into the ignition (do not turn it), then remove it. B. Repeat: insert the key into the ignition again (do not turn it), then remove it. This step must be performed quickly within five seconds.
  • Step 3: Door Cycling – Complete Within 40 Seconds A. Close and reopen the driver’s door. B. Repeat: close and reopen the door a second time. C. Insert the key into the ignition once more (do not turn it), then remove it.
  • Step 4: Final Setup – Complete Within 40 Seconds A. Close and reopen the driver’s door. B. Repeat: close and reopen the door again. C. Insert the key into the ignition and leave it inserted. D. Close the driver’s door fully. E. Turn the key to the ON position (do not start the engine), then turn it back to OFF. F. Remove the key from the ignition.
  • Step 5: Confirm Entry into Programming Mode Within 3 seconds of removing the key: The door locks should automatically lock and then unlock once. This confirms the system is ready to accept remote fobs. If this confirmation does not occur, restart the process from Step 1. Programming the Remote(s)
  • Step 6: Register Each Remote – Complete Within 40 Seconds Per Remote A. Press and hold the LOCK and UNLOCK buttons on the remote at the same time for approximately 1.5 seconds. B. Release both buttons, then press and hold the LOCK button alone for 2 seconds. C. The door locks should lock and unlock once, confirming that the remote has been successfully programmed. If the locks cycle twice, the remote was not accepted. Repeat this step.
  • Step 7: Program Additional Remotes (if needed) Repeat Step 6 for each additional remote you want to program. Typically, up to four remotes can be stored in the system’s memory.
  • Step 8: Exit Programming Mode To exit programming mode, simply open the driver’s door. The system will return to its normal state.
  • Final Testing Step 9: Verify Remote Functionality Test each programmed remote to confirm that all functions work correctly: Lock and unlock doors Panic button or other features, if equipped