<h1>2010 Honda Accord Keyless Entry Remote Fob Programming Instructions</h1> <p><font size="3"><b>Important Notice:</b> These instructions will only program the remote portion of the key. Entering programming mode will erase all previously programmed remotes, so you will need to reprogram all remotes. Be sure to complete each step within 5 seconds of the previous one to prevent the system from exiting programming mode prematurely.</font></p> <p><font size="3"> <b>Programming Procedure:</b> </font></p> <ul> <li><font size="3">Step 1: Turn the ignition switch to the ON (II) position, which powers the vehicle’s electronics without starting the engine. </font></li> <li><font size="3">Step 2: Press the LOCK or UNLOCK button on one of the remotes. (You can use an un-programmed remote for this step.)</font></li> <li><font size="3"> Step 3: Turn the ignition switch to the LOCK (0) position. This temporarily powers down the vehicle’s electronics, preparing it for reprogramming. </font></li> <li><font size="3">Step 4: Repeat Steps 1, 2, and 3 two more times, using the same remote that was used in Step 2. Ensure that each step is done within 5 seconds to prevent the system from exiting programming mode. </font></li> <li><font size="3">Step 5: Turn the ignition switch to the ON (II) position again. The vehicle is now in programming mode. </font></li> <li><font size="3">Step 6: Press the LOCK or UNLOCK button on the same remote used in Step 2. The power door locks should cycle (lock and unlock) to confirm that the vehicle is now in programming mode. </font></li> <li><font size="3">Step 7: Press the LOCK or UNLOCK button on each remote you wish to program. After each remote button press, the door locks should cycle to confirm that the system has accepted the remote. </font></li> <li><font size="3">Step 8: Repeat Step 7 for each additional remote you need to program. The door locks will cycle each time, confirming successful programming. </font></li> <li><font size="3">Step 9: Once all remotes have been programmed, turn the ignition switch to the LOCK (0) position to exit programming mode. This action saves the programming and prevents any further remotes from being added.</font></li> <li><font size="3"> Step 10: Test each remote by pressing the LOCK and UNLOCK buttons. The door locks should respond by locking and unlocking, confirming that the remotes are working correctly. </font></li> </ul> <p><b><font size="3">Note:</font></b></p> <ul> <li><font size="3"> Remote Head Key Programming: These steps will program the remote portion of the key. If you need to program the key blade portion, refer to your vehicle’s owner’s manual for instructions on key cutting and programming. If you have one working key, you can use a programming tool to program a spare key. Additional instructions for using a programming tool can be found in the vehicle’s manual or provided by authorized resources.</font></li> </ul>
