<h1>2010 Lincoln MKT Intelligent Access Key (Smart Key with Push-Button Start)</h1> <p><font size="3"><b>Important Information:</b> A maximum of four Intelligent Access Keys can be programmed to your vehicle. This process requires two existing programmed Intelligent Access Keys and one new, unprogrammed key. If fewer than two programmed keys are available, programming must be performed by a qualified technician using diagnostic equipment. Ensure the vehicle is turned off, and all doors are closed before and during the procedure. Complete each step within 30 seconds of starting. If any step is done out of sequence, wait at least one minute before starting over.</font></p> <p><font size="3"><b>Step-by-Step Smart Key Programming Procedure:</b></font></p> <ul> <li><font size="3">Step 1: Sit inside the vehicle with all doors closed and all keys within reach. </font></li> <li><font size="3">Step 2: Ensure the vehicle is off and do not press the brake pedal during this process. </font></li> <li><font size="3">Step 3: Place the new, unprogrammed Intelligent Access Key into the backup slot, located inside the center console utility compartment. </font></li> <li><font size="3">Step 4: Press the power unlock button (on either the driver or passenger door) three times. </font></li> <li><font size="3">Step 5: Press and release the brake pedal once.</font></li> <li><font size="3"> Step 6: Press the power lock button (on the driver or passenger door) three times. </font></li> <li><font size="3">Step 7: Press and release the brake pedal again. The START/STOP button indicator should begin to rapidly flash, indicating that programming mode has been activated and that two valid keys are detected. </font></li> <li><font size="3">Step 8: Within one minute, press the START/STOP button once. If successful, a message will appear confirming that the new key was programmed. If four keys are already programmed, the display will show ""MAX # OF FOBS LEARNED"" and you will not be able to add another until one is erased. </font></li> <li><font size="3">Step 9: Remove the newly programmed key from the center console backup slot. </font></li> <li><font size="3">Step 10: Press the lock or unlock button on the new key to exit programming mode. </font></li> <li><font size="3">Step 11: Test the new key to ensure: It starts the vehicle using the push-button ignition. It can lock and unlock the doors using the remote. All smart key features function as expected. If the new key was not programmed successfully, remove it, wait 10 seconds, and repeat Steps 1 through 11.</font></li> </ul>
