Programming Instructions for 2010 Mazda B-Series Keyless Entry Remote Fob

Important Notice: The 2010 Mazda B-Series is equipped with on-board programming functionality for keyless entry remotes. You can program up to two remotes during the same session. It’s important to follow the steps precisely and complete them within the recommended time frames.

Programming Procedure:

• Step 1: Verify that all doors are fully closed and the ignition is turned off.
• Step 2: Open the driver’s door, press the UNLOCK button on the interior door panel, and leave the door open.
• Step 3: Insert the key into the ignition.
• Step 4: Turn the key from OFF to RUN (just before the engine cranks) eight times within 10 seconds, stopping in the RUN position on the eighth turn. – The door locks will cycle, indicating the system has entered programming mode.
• Step 5: Within 20 seconds, press any button on the first remote. – The door locks will cycle, confirming the remote has been successfully programmed.
• Step 6: Within the next 20 seconds, press any button on the second remote (if needed). – The door locks will cycle again, confirming the second remote has also been programmed.
• Step 7: Turn the ignition back to the OFF position. – The door locks will cycle one final time, indicating the end of the programming session.
• Step 8: Test each remote to ensure both lock and unlock functions are operating correctly.
• Step 9: If the procedure was unsuccessful, repeat the process from Step 1 and ensure all actions are completed within the time limits.