<h1>Keyless Entry Remote Programming – 2010 Saturn Outlook</h1> <p><b>Important Notice:</b> The 2010 Saturn Outlook allows for onboard programming of keyless entry remotes. The procedure depends on whether the vehicle is equipped with Driver Information Center (DIC) buttons or not.</p> <p><b>For Vehicles Equipped with Driver Information Center (DIC) Buttons:</b></p> <ul> <li>Step 1: Turn the Ignition to ON Insert the key and turn it to the ON position (do not start the engine). This will activate the Driver Information Center display.</li> <li>Step 2: Navigate to the Relearn Option Press the Vehicle Information button until the message “PRESS TO RELEARN REMOTE KEY” appears on the screen.</li> <li>Step 3: Enter Programming Mode Press the Set/Reset button. The display will change to “REMOTE KEY LEARNING ACTIVE.”</li> <li>Step 4: Program the First Remote On the first remote, press and hold the Lock and Unlock buttons simultaneously for approximately 15 seconds. Wait for a chime, which confirms that the remote has been successfully programmed.</li> <li>Step 5: Program Additional Remotes (If Needed) Repeat Step 4 for each additional remote you wish to program. The vehicle can store up to eight remotes.</li> <li>Step 6: Exit Programming Mode Turn the ignition OFF and remove the key. Test each remote to confirm all functions are working properly.</li> </ul> <p><b>For Vehicles Without Driver Information Center Buttons:</b></p> <ul> <li>Step 1: Prepare the Vehicle Ensure the vehicle is in Park (P). Insert the key and turn it to the ON position (without starting the engine).</li> <li>Step 2: Access the Relearn Display Press the Trip Odometer Reset Stem repeatedly until “RELEARN REMOTE KEY” appears on the display.</li> <li>Step 3: Enter Programming Mode Press and hold the Trip Odometer Reset Stem for about 3 seconds. The display will then show: “REMOTE KEY LEARNING ACTIVE.”</li> <li>Step 4: Program the First Remote Press and hold the Lock and Unlock buttons on the first remote simultaneously for 15 seconds. A chime will sound once the programming is complete.</li> <li>Step 5: Program Additional Remotes (If Needed) Repeat Step 4 for any other remotes you wish to add. The system can accept up to eight remotes total.</li> <li>Step 6: Finalize the Process Turn the ignition OFF and remove the key. Test each remote to verify full functionality.</li> </ul>
