Keyless Entry Remote Fob Programming Instructions for the 2010 Scion tC

Note: These steps program only the remote functions of the remote head key. The key blade must be physically cut and the immobilizer chip programmed by a qualified professional.

Step-by-Step Programming Procedure:

• Step 1: Begin with the key removed from the ignition.
• Step 2: Open and unlock the driver’s door. Ensure all other doors—including the trunk—are closed.
• Step 3: Within 5 seconds, insert the key into the ignition and remove it twice.
• Step 4: Close and open the driver’s door two times.
• Step 5: Insert the key into the ignition once more, then remove it.
• Step 6: Close and open the driver’s door two more times.
• Step 7: Insert the key into the ignition again and leave it in.
• Step 8: Close the driver’s door.
• Step 9: Turn the ignition ON, then OFF (do not start the engine).
• Step 10: Remove the key from the ignition.
• Step 11: The door locks should cycle (lock and unlock) once, indicating the vehicle has entered remote programming mode.
• Step 12: On the first remote: Press and hold both the LOCK and UNLOCK buttons simultaneously for approximately 1.5 seconds. Release both buttons, then immediately press and hold the LOCK button for about 2 seconds.
• Step 13: The door locks will cycle again to confirm successful programming of that remote. To program additional remotes, repeat Step 12 for each one within the same session.
• Step 14: Open the driver’s door to exit programming mode. All programmed remotes should now function properly.