<h1>2011 Honda Accord Keyless Entry Remote Fob Programming Instructions</h1> <p><font size="3"><b>Important Notice:</b> These instructions will only program the remote portion of the key. Entering programming mode will erase all previously programmed remotes, so you will need to reprogram all remotes. Be sure to complete each step within 5 seconds of the previous one to prevent the system from exiting programming mode prematurely. </font></p> <p><font size="3"><b>Programming Procedure:</b> </font></p> <ul> <li><font size="3">Step 1: Turn the ignition switch to the ON (II) position. This will power the vehicle’s electronics without starting the engine.</font></li> <li><font size="3"> Step 2: Press the LOCK or UNLOCK button on one of the remotes. (You can use an un-programmed remote for this step.) </font></li> <li><font size="3">Step 3: Turn the ignition switch to the LOCK (0) position. This temporarily powers off the vehicle’s electronics, preparing it for reprogramming. </font></li> <li><font size="3">Step 4: Repeat Steps 1, 2, and 3 two more times using the same remote from Step 2. Be sure to complete each action within 5 seconds to keep the system in programming mode. </font></li> <li><font size="3">Step 5: Turn the ignition switch to the ON (II) position again. This will indicate that the vehicle is in programming mode. </font></li> <li><font size="3">Step 6: Press the LOCK or UNLOCK button on the same remote used in Step 2. The power door locks should cycle (lock and unlock), confirming that the vehicle is now in programming mode.</font></li> <li><font size="3"> Step 7: Press the LOCK or UNLOCK button on each remote you want to program. After pressing each remote's button, the door locks should cycle, confirming that the system has successfully accepted the remote. </font></li> <li><font size="3">Step 8: Repeat Step 7 for each additional remote you need to program. The door locks will cycle after each press, indicating that the system has successfully learned the remote. </font></li> <li><font size="3">Step 9: Once all remotes have been programmed, turn the ignition switch to the LOCK (0) position to exit programming mode. This finalizes the programming process and prevents further remotes from being added.</font></li> <li><font size="3"> Step 10: Test each remote by pressing the LOCK and UNLOCK buttons. The door locks should respond by locking and unlocking, confirming that the remotes are working properly. </font></li> </ul> <p><b><font size="3">Note:</font></b></p> <ul> <li><font size="3"> Remote Head Key Programming: These steps will program the remote portion of the key. If you need to program the key blade portion, refer to the vehicle’s owner’s manual for instructions on key cutting and programming. If you have one working key, you can use a programming tool to program a spare key. Additional instructions for using a programming tool are available in your vehicle’s manual or from authorized resources.</font></li> </ul>
