<h1>2011 Honda Pilot Keyless Entry Remote Fob</h1> <p><font size="3"><b>Note:</b> These instructions program the remote functions only (lock/unlock/trunk). Programming the ignition chip portion requires separate equipment. </font></p> <p><font size="3"><b>Step-by-Step Programming Instructions</b> </font></p> <ul> <li><font size="3">Step 1: Prepare the Vehicle Sit in the driver’s seat with all doors and rear hatch/trunk closed. Have all remotes to be programmed ready. You only need one to start the process, but all must be programmed during the same session. </font></li> <li><font size="3">Step 2: Begin the Programming Sequence Insert the key into the ignition. Turn the key to the ON position (position “II”, where the dashboard lights come on). Within 5 seconds, press the LOCK button on the remote for about 1 second, then release. </font></li> <li><font size="3">Step 3: Turn Off the Ignition Turn the key to the OFF position (position “I”, where dashboard lights turn off). </font></li> <li><font size="3">Step 4: Repeat the Cycle Repeat Steps 2 and 3 three more times (for a total of four cycles). Each step must be performed within 5 seconds of the previous one. </font></li> <li><font size="3">Step 5: Enter Programming Mode After the fourth time turning the key to ON, press the LOCK button on the remote again. You should hear the door locks cycle once (clicking noise only). This sound confirms the vehicle has entered programming mode. Do not turn the key off. </font></li> <li><font size="3">Step 6: Program the Remotes Within 5 seconds, press the LOCK button on each remote you want to program (one at a time), holding for about 1 second and then releasing. Each time you press a remote, the locks will cycle once to confirm it was accepted. You may program up to 3 remotes during this session. This step must be completed within 10 seconds. </font></li> <li><font size="3">Step 7: Exit Programming Mode Turn the key to the OFF position and remove it. Exit the vehicle and close the door. Test each remote to ensure that all functions work properly. </font></li> </ul> <p><font size="3"><b>Additional Notes:</b> Use remotes with fresh batteries for the best results. Follow timing precisely—delays may cancel programming mode. If equipped with a trunk/hatch release, hold that button for 2–3 seconds to activate.</font></p>
