<h1>2012 Honda Accord Keyless Entry Remote Fob Programming Instructions</h1> <p><font size="3"><b>Important Notice:</b> These instructions will only program the remote portion of the key. Entering programming mode will erase all previously programmed remotes, so you must reprogram all remotes once you are in programming mode. Be sure to complete each step within 5 seconds of the previous one to prevent the system from exiting programming mode prematurely. </font></p> <p><font size="3"><b>Programming Procedure:</b> </font></p> <ul> <li><font size="3">Step 1: Turn the ignition switch to the ON (II) position. This will power up the vehicle’s electronics without starting the engine. </font></li> <li><font size="3">Step 2: Press the LOCK or UNLOCK button on one of the remotes. (You can use an un-programmed remote for this step if necessary.)</font></li> <li><font size="3"> Step 3: Turn the ignition switch to the LOCK (0) position. This temporarily powers off the vehicle’s electronics, preparing the system for reprogramming. </font></li> <li><font size="3">Step 4: Repeat Steps 1, 2, and 3 two more times using the same remote as in Step 2. Ensure each action is completed within 5 seconds to keep the system in programming mode. </font></li> <li><font size="3">Step 5: Turn the ignition switch to the ON (II) position again. The vehicle will now be in programming mode. </font></li> <li><font size="3">Step 6: Press the LOCK or UNLOCK button on the same remote you used in Step 2. The power door locks should cycle (lock then unlock) to confirm that the vehicle is now in programming mode. </font></li> <li><font size="3">Step 7: Press the LOCK or UNLOCK button on each remote you want to program. After pressing each remote's button, the door locks should cycle, confirming that the system has accepted the remote.</font></li> <li><font size="3"> Step 8: Repeat Step 7 for each additional remote you need to program. The door locks will cycle after each press, indicating that the remote has been successfully programmed. </font></li> <li><font size="3">Step 9: Once all remotes are programmed, turn the ignition switch to the LOCK (0) position to exit programming mode. This action saves the programming and prevents further remotes from being added. </font></li> <li><font size="3">Step 10: Test each remote by pressing the LOCK and UNLOCK buttons. The door locks should respond by locking and unlocking, confirming that the remotes are working properly. </font></li> </ul> <p><font size="3"><b>Note:</b> </font></p> <ul> <li><font size="3">Remote Head Key Programming: These steps will program the remote portion of the key. If you need to program the key blade portion, refer to the vehicle’s owner’s manual for instructions on key cutting and programming. If you have one working key, you can use a programming tool to program a spare key. Additional instructions for using a programming tool are available in your vehicle’s manual or from authorized resources.</font></li> </ul>
