<h1>2012 Lincoln MKT Intelligent Access Key (Smart Key with Push-Button Start)</h1> <p><font size="3"><b> Important Notes:</b> A maximum of four Intelligent Access Keys can be programmed to your vehicle. You must have two valid, previously programmed keys and one new, unprogrammed key to complete this procedure. If you do not have two working keys, the key must be programmed by a professional technician using diagnostic equipment. Ensure the vehicle is off and that all doors remain closed during the entire process. Perform all steps within 30 seconds. If a step is missed or performed out of order, wait one full minute before restarting the process. </font></p> <p><font size="3"><b>Step-by-Step Smart Key Programming Procedure:</b></font></p> <ul> <li><font size="3">Step 1: Sit inside the vehicle with the doors closed and all keys readily accessible. </font></li> <li><font size="3">Step 2: Ensure the vehicle is off and your foot is not on the brake pedal. </font></li> <li><font size="3">Step 3: Place the new, unprogrammed Intelligent Access Key in the backup slot, located inside the center console utility compartment. </font></li> <li><font size="3">Step 4: Press the unlock button on the driver or passenger door three times. </font></li> <li><font size="3">Step 5: Press and release the brake pedal once. </font></li> <li><font size="3">Step 6: Press the lock button on the driver or passenger door three times. </font></li> <li><font size="3">Step 7: Press and release the brake pedal again. At this point, the START/STOP button indicator should begin to rapidly flash, signaling that the vehicle has entered programming mode and recognized two valid keys inside the cabin. </font></li> <li><font size="3">Step 8: Within one minute, press the START/STOP button once. If the programming is successful, the vehicle will accept the new key. If four keys have already been programmed, the message ""MAX # OF FOBS LEARNED"" will appear on the dashboard. </font></li> <li><font size="3">Step 9: Remove the newly programmed key from the center console backup slot. </font></li> <li><font size="3">Step 10: Press the lock or unlock button on the newly programmed key to confirm exit from programming mode. </font></li> <li><font size="3">Step 11: Test the new key to ensure it: Starts the engine using push-button start. Locks and unlocks the doors with the remote. Activates all Intelligent Access features as expected. If the key fails to program correctly, remove it, wait 10 seconds, and repeat Steps 1 through 11.</font></li> </ul>
