2012 Lincoln MKX

2012 Lincoln MKX Keyless Entry Remote Fob Smart Key

Step-by-Step Programming Instructions:

  • Programming Spare Intelligent Access Keys You must have two previously programmed Intelligent Access Keys inside the vehicle and the new unprogrammed Intelligent Access Key readily accessible. If two previously programmed keys are not available, you will need a professional to program the spare key(s).

Note: A maximum of four Intelligent Access Keys can be programmed to your vehicle. If you want to replace a previously programmed key or already have four keys programmed, a professional will need to erase old keys before programming new ones.

Preparation:

  • Make sure the vehicle ignition is switched off. - Close all doors before beginning and ensure they remain closed throughout the process. - Complete all steps within 30 seconds of beginning the procedure. - If any steps are performed out of sequence, wait at least one minute before retrying. - Review the full instructions before starting.

Programming Procedure:

  • Step 1: Open the center console utility compartment lid.
  • Step 2: Place the new, unprogrammed Intelligent Access Key in the backup slot located inside the center console compartment.
  • Step 3: Press the driver or passenger side power door unlock control three times.
  • Step 4: Press and release the brake pedal once.
  • Step 5: Press the driver or passenger side power door lock control three times.
  • Step 6: Press and release the brake pedal again once. The Start/Stop button indicator should begin flashing rapidly, indicating that programming mode has been activated.
  • Step 7: Within one minute, press the Start/Stop button. If four Intelligent Access Keys have already been programmed to the vehicle, the message ""MAX # OF FOBS LEARNED"" will appear in the message center.
  • Step 8: Remove the newly programmed Intelligent Access Key from the console pocket.
  • Step 9: Press the UNLOCK button on the newly programmed key to exit programming mode.
  • Step 10: Test the remote by locking and unlocking the doors. Also, ensure the engine starts using the new Intelligent Access Key.

Note:

  • If programming was unsuccessful, wait 10 seconds and repeat steps 1 through 10.